Air

  • All
  • Air
  • Chassis & Frame
  • Driveshaft
  • Engine
  • Front End
  • Fuel
  • Ignition
  • Lighting
  • Suspension
  • Wiring
AirFuelIgnition

How to remove carburettors on a Suzuki Intruder VS1400

Removing the air boots The first thing you need to do is to loosen a couple of ring clips. These ring clips are fastened and …

See Guide →
Air

How to remove the air box on a Suzuki Intruder VS1400

Rear Airbox Removing the rear airbox is actually quite simple. There are some 10mm bolts to remove – One on the front outside of the …

See Guide →
Chassis & Frame

How to remove the rear fender of a Suzuki Intruder VS1400

Removing the indicators First, we need to remove the indicators. If they are stock indicators, they’ll have a threaded stalk going through the frame with …

See Guide →
Front EndLightingWiring

How to remove the headlight on a Suzuki Intruder VS1400

There are four screws in total on the exterior of the headlight, two inset screws which adjusts the position of the headlight (you do not …

See Guide →
Chassis & Frame

How to remove the radiator on a Suzuki Intruder VS1400

First, drain the oil as the oil in the sump supplies all the components on the bike and if we start removing bolts or seals …

See Guide →
IgnitionLightingWiring

How to remove wiring harness on a Suzuki Intruder VS1400

Front wiring loom As we’ve removed the radiator in a previous tutorial, it’ll be a lot easier the free the horn, front indicator and headlight …

See Guide →
Chassis & Frame

How to remove speedometer on a Suzuki Intruder VS1400

Footplates and exhaust This section may not be applicable to you, depending on modifications. Once you’ve jacked up the bike and strapped it on to …

See Guide →
Suspension

How to remove rear shocks & struts on a Suzuki Intruder VS1400

There are three fixing points on the rear brackets, one at the top of the suspension, one by the swing arm that goes straight into …

See Guide →
Chassis & FrameFront End

How to remove brake calipers on a Suzuki Intruder VS1400

Draining the brake fluid Brake fluid is corrosive, so make sure you are wearing clothes you don’t care about, don’t have any exposed skin and …

See Guide →
Chassis & FrameFront End

How to remove front wheel, forks, controls Suzuki Intruder VS1400

Foot controls In the last video we drained the brake fluid, so please do that before following my steps as we are going to disconnect …

See Guide →
Chassis & FrameDriveshaft

How to remove rear wheel and swing arm Suzuki Intruder VS1400

Removing the rear axel First, remove the rear tyre. Before we remove the axel take note of the metal axel spacer on the right-hand side …

See Guide →
Fuel

Carburettors 101 – Suzuki Intruder VS1400

If your bike has been sat for a while, you may have an issue getting it started, and if it does start, you may have …

See Guide →
Select your currency
USD United States (US) dollar